1/48 AMT/ERTL S-3A/B
Viking |
 |
Gallery
Article by Ted Taylor |
|
|
|
1/48 AMT/ERTL S-3A/B Viking
with Paragon slats and flaps and CAM decals
Paragon
does a slats and flaps set for the Viking and I have used these along with the
new decal sheet from CAM decals for VS-21.
|
Click on
images below to see larger images
|
|
|
This
job is fairly straightforward it is just a case of cutting the kit
flaps off and replacing them with new interior wing spars and hanging the flaps
on, very simple. My method of mounting the flaps is to add four lengths of
florists wire to each flap where the screw jacks would be and drill matching
holes in the spar, then push the wires into the holes and bend the flap down to
the required angle, the holes must be a tight fit though you can then adjust to
suit.
